Alaska Achievers Blog Hop Using Springtime Foils Specialty DSP
Donut Give Up Spiral Notebook and Card

Anti-Bac Coffee Gift Box

A great gift for coffee lovers.  

Anti-Bac Coffee Gift Box

by Phyllis Shepherd, Independent Stampin’ UP!® demonstrator



Whisper White Cardstock - #100730

Crushed Curry Cardstock - #131199

Coffee Break Designer Series Paper - #144155

accessories/adhesive/ink pads

Bone folder - #102300

Multipurpose Liquid Glue - #110755

Stampin’ Dimensionals- #104430

Stampin’ Trimmer - #126889

Envelope Punch Board -#133774

Big Shot Die-Cutting Machine - #143263

Magnetic Platform - #130658

Coffee Cups Framelits - #143745

Corrugated Elements - #144158

stamp set

Coffee Café – #143677


  • Crushed Curry Cardstock – 5 ¼” x 5 ¼”
  • Punch and score @ 1 ½” & then at 2 7/8” on the first side; then rotate 90⁰ to the left. Use the score guides on the remaining 3 sides to complete 8 punches and score lines. Use the rounder on the side of the punch board to round only the top flap of the box.


  • Burnish the scored lines with the Bone Folder and then cut as shown in the picture. Notice the cuts on the rounded flap (the top of the box) are cut downward and the flaps for the bottom are cut sideways.


Below: Measure over from the scored line 1 ½” as shown in the picture. Cut the tip off each side so it will go together correctly.  If you download the file link below at the end of the last photo, you can see what it will look like.

Take the bottom flaps and begin to form the box. Use Liquid Glue to adhere the flaps to the side panels and

then the trimmed panels to the front to form the box. You should insert the Anti-bac container inside to ensure

a proper fit. Hold until the glue has set.

  • Stamp the saying from Coffee Café in Crushed Curry Ink on a piece of Whisper White Cardstock.
  • Coffee Break Designer Series Paper - 1 ½” x 6 ½”, form this around the box and adhere in the back.
  • Use the Big Shot Die-Cutting Machine to make a ‘sandwich’ in this order: Magnetic Platform, a standard cutting pad, the stamped image and the oval die from the Coffee Cups Framelits Dies, and lastly the other standard cutting pad. Run this ‘sandwich’ through the machine. Layer this piece to an oval from the Corrugated Elements. Adhere the mat to the front of the box with a Stampin’ Dimensional.  


If you would like a file of this project or would like to see how the box is pieced together, click the link below:

Download 220.Anti-Bac Coffee Gift Box

Thank you so much for stopping by.  Please subscribe to this blog so you do not miss anything.


Feed You can follow this conversation by subscribing to the comment feed for this post.

The comments to this entry are closed.